Tiny Camera Adds to Wide Range of Services of
ETTL Engineers & Consultants Inc. for Ground-Water Monitoring and Recovery
Wells
Do you own and/or operate ground-water
(G-W) monitoring and/or recovery wells?
As readers located in
Well Inspection inside the Well
Itself!
The photos below were taken during an evaluation of three recovery
wells, made for an ETTL client. Averaging 25' bgs, the wells had been in service
for some time and had become inefficient.
From the information ETTL gathered, an appropriate rehabilitation scheme
was developed. With the help of ETTL's
Geo-VISION camera and video system, it was discovered that the bottom cap of
one well was defective; and the well was replaced. The structure of the other two wells passed
muster, but each required a new pump.
ETTL pulled the old ones and installed a Grundfos Redi-Flow 3 Submersible
Pump – a "smart" pump with built-in safeguards and controls – in each well, as well as in the new
(replacement) well.
How the Camera and Monitor Are Used With
a Pipe String
The Geo-VISION camera has its own
light. It first is attached to narrow PVC pipe. The centralizer is used to keep the camera
centered in the well to be inspected. It
then is lowered into the well so inspection can be carried out. More sections of PVC pipe are added until the
camera reaches the bottom of the well.
The well's condition is continuously displayed on the monitor and is recorded
audio-visually. ETTL uses the Geo-VISION to
help identify the integrity and operating
efficiency of wells from 1¼" to 24" diameter. The camera
housing can operate in pressures to 200 psi (equal to 426 ft underwater).
